Q: What exactly does the “5 Inch Any Angle” connector do?
A: It’s a flexible jumper that links two sections of 10mm single-color LED strip using a 5 inch cable between them. This lets the strip run cross gaps, turn corners, or route around obstacles while keeping continuous light and electrical connection.
Q: Which LED strips are compatible with this connector?
A: The connector is designed for 10mm wide single-color LED strips in 12V or 24V systems. It works with most standard indoor, outdoor, and waterproof single-color strip formats, as long as the tape width is 10mm and the cut pads align with the 2-pin layout.
Q: Can this connector be used with dimmable LED strip setups?
A: Yes. The any-angle connector is compatible with dimmable single-color LED strip installations and can be used between the strip and a dimmable power supply or dimmer, provided all components share the same voltage and load ratings.
Q: Do I need tools or soldering to install it?
A: No tools or soldering are required. Each end uses a snap-close clasp that attaches to the cut strip section; the installer simply opens the connector, seats the LED strip pads, and snaps it closed to create a secure electrical connection.
Q: Can it act as a strip-to-wire pigtail?
A: Yes. By cutting one end off the jumper and stripping the internal conductors, the connector can be used as a strip-to-wire pigtail to connect a 10mm strip to a power supply, dimmer, or other wiring accessory, following standard low-voltage wiring practices.
Q: Is it possible to create T-style connections with these?
A: It is. Multiple 5 inch any-angle jumpers can be combined to form simple T-connectors, for example by using three strip-to-wire pigtails to branch the strip in two directions from a main run, as demonstrated in HitLights’ connector guidance content.
Q: Can I bend the jumper to a sharp 90-degree corner without damaging the strip?
A: Yes, the cable itself is designed to be fully bendable, so corners and tight angles are made in the jumper, not the LED strip. This reduces stress on the strip and supports L-shaped or irregular layouts without kinking or cracking the LED tape.
SHIPPING DETAILS:
